Jezmat systems have been developed for the protection of cables within the confines of a building structure. Specifically designed to provide a flat cabling surface for the high demands of data cabling. The material used is a one-piece ribbed extrusion that is both very strong and light.

• Tough, durable and impact resistant.
• Will not compress under cable load.
• Varying widths, thickness and load bearing strengths available
• Most colours available for easy route designation
• Clear options also available

With the requirement for faster and faster data transmission that in turn evolved in the adoption of the CAT6, CAT6A and now CAT 7 cabling systems. Consideration must be given to methods of installation and protection of these cables, which are now required to perform at many times the speed of standard CAT 5 cables. It is no longer acceptable to run these cables in raised floor locations directly onto an uneven floor surface or to bump over the wires in a standard cable basket, as this can induce deformation in the signal being transmitted.

Greater care is also required to ensure there is no ingress of water penetration in the wiring looms, as this again can affect the data transmission. Water damage can come from many areas of local flooding, down the riser shaft as the building nears completion, a burst pipe, or defective tea machine. All of these can cause sufficient water to cause a local flood if the cables are being laid directly onto the floor surface. It should be remembered that a cable installation is not just for today but also to provide a lifetimes service.

To meet this level of cable support and protection the Jezmat Containment System has been developed.